Testinside cisco CCIE 350-001

CCIE Cisco Certified Internetworking Expert : 350-001 Exam

Exam Number/Code: 350-001
Exam Name: CCIE Cisco Certified Internetworking Expert

“CCIE Cisco Certified Internetworking Expert”, also known as 350-001 exam, is a Cisco certification.
Preparing for the 350-001 exam? Searching 350-001 Test Questions, 350-001 Practice Exam,350-001 Dumps?

Free 350-001 Demo Download
TestInside offers free demo for 350-001 exam ( CCIE Cisco Certified Internetworking Expert). You can check out the interface, question quality and usability of our practice exams before you decide to buy it. We are the only one site can offer demo for almost all products.

QUESTION 21
Certkiller has a frame-relay network with 2 sites; a headquarters site and a remote
site, each with a PVC connecting the 2 sites. The network is running RIPv2.
Certkiller is now expanding and adding another remote site in the frame relay
network and has ordered a second PVC between the new remote site and the
headquarters site. All frame-relay interface IP addresses are in a single subnet.
Certkiller has configured frame-relay DLCI mappings and can successfully ping
from the new remote to the headquarters site as well as the other remote site.
However, the new router does not have a route in its route table to the other remote
site’s LAN, and cannot ping the LAN interface or any hosts on that LAN. What is
most likely causing the problem?
A. Neighbor statements are not configured on the two remote sites, pointing to all other
sites.
B. The headquarters site router has split-horizon enabled on the frame-relay interface.
C. The frame-relay IP to DLCI mappings are incorrectly configured.
D. RIP cannot propagate routing updates over a partial mesh frame-relay configuration,
so another routing protocol should be selected.
E. Triggered updates should be configured on the headquarters router, to directly forward
routing updates between the two remote sites.
F. None of the above
Answer: B
Explanation:
RIP version 2 is a distance vector routing protocols, and by default all distance vector
routing protocols utilize the split horizon rule to avoid routing loops. The split horizon
rule blocks routing updates to be sent over the same interface that the route was learned
from. In this case, the routes from the remote frame relay sites will not be sent to the
other remote locations. In a hub and spoke topology such as this, the only way to ensure
full connectivity between all locations using RIPv2 is to use sub-interfaces, or to disable
the use of split horizons on the physical serial interface.
QUESTION 22
Layer 6 of the OSI model is responsible for which of the following functions?
A. Common Data Compression and Encryption Schemes
B. Establishing, managing, and terminating communication sessions
C. Synchronizing communication
D. Determining resource availability
E. None of the above
Answer: A
Explanation:
Layer 6 is the Presentation Layer. This layer provides independence from differences in
data representation (e.g., encryption and compression) by translating from application to
network format, and vice versa. The presentation layer works to transform data into the
form that the application layer can accept. This layer formats and encrypts data to be sent
across a network, providing freedom from compatibility problems. It is sometimes called
the syntax layer.
Incorrect Answers:
B: This describes layer 5 of the OSI model, which is the Session Layer.
C, D: These are not responsibilities of the Presentation Layer.
QUESTION 23
Part of the configuration of router CK1 is shown below:
interface Ethernet0/0
ip address 10.1.1.1 255.255.255.0
ip summary-address rip 10.2.0.0 255.255.0.0
350-001
Actualtests.com – The Power of Knowing
half-duplex
!!
router rip
network 10.0.0.0
You have configured RIPv2 summarization on the CK1 interface Ethernet 0/0 but
the routes are still not being summarized. Based on the information provide above,
what could be causing the problem?
A. You need also to enable the auto summerazation under the RIP process.
B. You need also to disable the auto summerazation under the RIP process.
C. RIP does not support summarization on interface basis.
D. Split horizon is enabled on the Ethernet 0/0 interface
E. The mask configured on the “ip summary-address” command must be /24 bits.
F. None of the above
Answer: D

Testinside CCIE 350-001 Questions and Answers : 361 Q&As
Updated: October 15th , 2008
Price: $159.99 $99.99

Free download：pass4sure CCIE 350-001
Free download：testking CCIE 350-001

password : www.ciscoexams.org